EIS 500

Product Enquiry Sheet

Manufacturing facilities are in the process of being set up and we need to determine in more detail what range of product is required.

The EIS 500 is a stainless steel clad Vacuum Super Insulation panel achieving insulation values typically of 2 to 5 mW/m.K at 20C, depending upon size etc. It can be used anywhere where high insulation and strength can give you a competitive advantage.

Preliminary research, carried out by Cardiff University, indicated that a panel of 1000mm x 1000mm x 20mm would be the ideal size to produce. We need to determine more accurately what our potential customers actually want and at what price it would be economical.

We can use different fillers which will affect both the insulation values and the costs and could probably accommodate most requirements, but this is likely to be too expensive; so we aim to produce a small range of standard products that we hope will satisfy the majority.

Initially we will limit our panels to operating in the range of -150C to 600C.
The proposed standard panel will weigh about 4kg and will probably be dimpled on the working surface.
The top and bottom skins will be made from 0.1mm Stainless Steel and will be bright and shiny.
We expect our panels to have a designed life in excess of 25 years, but we could probably make a panel with shorter life at less cost.

Thickness
mm
Length
mm
Width
mm
U Value
W/m²K
Life
Needed
Estimated
Quantities
Target
Price/m²
Comments
10 1000 500          
15 1000 500          
20 1000 500          
25 1000 500          
30 1000 500          
35 1000 500          
40 1000 500          
45 1000 500          
50 1000 500          

If you have any other particular requirements, please indicate below.

Thickness
mm
Length
mm
Width
mm
U Value
R Value Life
Needed
Estimated
Quantities
Target
Price/m²
Comments
10 1000 500            
15 1000 500            
20 1000 500            
25 1000 500            
30 1000 500            
35 1000 500            
40 1000 500            
45 1000 500            
50 1000 500            

Although we will initially concentrate on making flat panels it should be possible to make many different shapes and  configurations prior to final assembly. Manipulation or deformation after assembly is unlikely to be possible without damaging the assembly.

 

Please complete this form and return it to:

Fax: 0044 (0)1639 681972

Superline Ltd.
Uplands, Unit 1
14 Old Road
Baglan
Port Talbot
SA12 8TT
Tel: 0044 (0)1639 681972
Email: info@eisgroupltd.com

From:

Company:
Address:
 
Tel:
Fax:
Email:
Name:
Signature:

Open as PDF Document! (16kb)

When you click on the above link it will open up the document within a browser page if you go to File and save as you can choose where you would like to save the file.

Alternatively you could print the document from here. Go to File then print.

Typical Edge Loss characteristics:-
VSI performance graphs